Universal rear release for planer boards, Ice shanty light kit, enclosed trailer light kit

Our Folding LED Cluster Lights were designed primarily for hub style ice shanties because these lights can be attached in very small spaces to any support pole of the hub, including at the top.  The independent folding light panels provide the user with the ability to rotate the panels in order to aim the light in different directions and since hub style shanties tend to have a rounded shape, being able to point the light in different directions allows the user to light up specific areas of their hub shanty as needed.   Like our LED light bars, the LED color in our Cluster Lights is in the warm white color spectrum which is the perfect color to minimize eye strain.  Each Cluster Light produces around 1000 lumens and every Kit includes a padded storage bag so that the light and all components can be taken down and stored in the bag between ice fishing trips.  The DUAL Cluster Light Kit will come with two padded storage bags.

​

CUSTOMERS WITH EXISTING LIGHT BAR KITS SEE BELOW.

 

IMPORTANT NOTES ABOUT POWER SOURCES SEE BELOW. 

​

12V Power Sources

If you are using a 12V power source such as a sealed lead acid or lithium battery, or a 12V power box, then up to 3 Cluster Light can be powered together either in series or in parallel.  To run them in parallel so that you can conveniently spread the lights apart in your hub from a common center point, you need to use our 1 x 3 Power Splitter Cord.  A pictorial example of how to do this is shown here.   

​

USB Power Source

If you are using a USB power source, you can only power 1 Cluster Light at a time due to design limitations in our USB power cord circuit.  DO NOT power more than 1 Cluster Light when powering our Cluster Light by USB.

​

CUSTOMERS WITH EXISTING LIGHT BAR KITS

If you have an existing light bar kit WITH NO MORE THAN 2 LIGHT BARS and you are powering your kit with a 12V power source such as a sealed lead acid or lithium battery, or a 12V power box,  then you can add ONE additional Cluster Light to your kit in series with the interconnect cord that is supplied with the Add-On LED Cluster Light Kit.  To run them in parallel so that you can conveniently spread the lights apart in your hub from a common center point, you will need to use our 1 x 3 Power Splitter Cord.

​

​

WARNINGS: 

 

Do NOT power more than ONE Cluster Light at a time with our USB power cord.  Exceeding ONE Cluster Light connected together will overload the current carrying capacity of the USB power converter circuit and may result in injury to you or damage to your equipment.  It is normal for the USB connector (and sometimes your power bank) to become slightly warm during operation.  It is also normal for the USB power plug to have a slight buzz to it depending on the battery USB's output circuit design.  Some power banks are absolutely quiet while others are not.

​

Do NOT exceed 3 Cluster Lights connected together in series or in parallel when using a 12V power supply.  Exceeding 3 Cluster Lights connected together when using a 12V power supply will overload the current carrying capacity of the power wires and may result in injury to you or damage to your equipment

​

Do NOT exceed ONE Cluster Lights connected together in series or in parallel with TWO LIGHT BARS when using a 12V power supply.  Exceeding this combination of ONE Cluster Light with TWO light bars will overload the current carrying capacity of the power wires and may result in injury to you or damage to your equipment